AT&T EL52300 DECT 6.0 Cordless Phone, Silver/Black, 3 Handsets.AT&T EL52300 DECT 6.0 Cordless Phone, Silver/Black, 3 Handsets.For any further queries please contact AT&T’s Technical Support Number/ Customer Support Number @ 1-800-222-3111. TROUBLE-SHOOTING STEPS: Why don’t I get a dial tone on my handset? • Make sure that the power cord is securely plugged into the base and electrical outlet. Make sure the electrical outlet is not controlled by a wall switch. • Check the installation of the unit. Make sure the telephone line cord is connected from the base unit to a telephone jack. If the cord is already plugged in, unplug the cord at both ends and reconnect. • Your handset being out of range of the base may cause a poor connection. Move the handset closer to the base. The operating range may vary with environmental conditions and time of use. There may be places within your environment that a cordless phone will not work well. If the problem only occurs in certain areas of your environment, you can conclude that there is nothing wrong with the phone. • When placing the handset in the charging base, confirm that the charge contacts on the handset and base are making a good connection. The CHARGE light on the telephone handset will be on when the handset is charging. • You may have a defective telephone cord. Try replacing cord between the jack and the telephone base. • If you have connected this telephone to a phone jack that has not been used before, or that has not been used in sometime, there may be problems with this jack that you are not aware of. Use a telephone jack that you know is in proper working order. • If the other phones in your home are having the issue, the problem could be related to the telephone wiring in your home, or with your local telephone service. Please call your service provider for further assistance. • Does your handset display 1. Press HS Loc on Base 4 sec 2. Then Press # on Handset You need to register the handset to its base. Follow the above steps. • If the handset is not responding normally, you may need to reset your telephone system. Complete the following steps to reset the telephone system: Step 1: Disconnect the power to the telephone base. Step 2: Disconnect the handset battery(s). Step 3:Wait a few minutes and then reconnect the power to the telephone base. Step 4: Reconnect the handset battery(s). Step 5: Wait about one minute for the handset to re-establish a link with the telephone base and then test the phone again.
- DECT 6.0 Digital Technology, DSL Subscribers may need to us a DSL Filter..
- Handset Speakerphones, Three Handset System (use 3 handsets through a single phone jack)
- Lighted Keypad on Handsets, Caller ID/Call Waiting Capability*
- Up to 14 Minutes of Digital Recording Time*** , For optimal performance batteries should be charged for 16 hours prior to use
- No headset jack.